ASSEMBLY INSTRUCTIONS SIDE DECKSPart # 420865-10READ THROUGH AND UNDERSTAND ALL THE STEPS TO THIS INSTALLATION BEFORE ATTEMPTING TO INSTALL EITHER YOU
108ANGLE SUPPORT BARS TO DECKWhere the Posts fasten to the deck, attach Angle Support Bars. The illustrations below indicate which of the Close-up ill
113” SPECIAL POSTS / CHECK YOUR WORK AND TIGHTENAttach the 3” special post to the fence post brackets installed underneath your deck using the 2” scre
12Secure the two deck ledges and the ledge section of each 4’x5’ patio to the top plates. Drill a ¼” hole in the deck ledges and secure to the top pl
13Before assembling your pool, drill the required holes in the Verticals and Buttress post.Simply place the bracket 7¾” from the top of the Vertical o
1414Use the illustrations below for reference during attaching the sections of Fence to the Fence Posts as described on the following pages.
15Using the illustration for your size deck on the previous page, assemble the Fence Postions. Note carefully the location for the different sizes.
16WARNING LEDGE PLACEMENTENTRY POINTVIEW FROM INSIDE THE DECKLATCHGATEPOSTSELF CLOSING HINGEGATELATCH BARUsing the Latch, Latch Bar and Hinges as temp
GENERAL Take time to follow the instructions and do things right the fi rst time. Read all instructions prior to starting. Before you start, check t
ASSEMBLY DRAWINGSUse the drawings below for reference while assembling your deck.During assemly please note that the ledges on the pool are to be remo
41Clear out and level the ground in the location where your deck is to be installed.Use the following chart for the area size:POOLDECKAB2SIZE A B12 x
53Start Here or HerePOSITION YOUR FIRST DECK SECTIONStarting at the fi rst or last (left or right) vertical of the straight side of th
64POSITION THE REMAINING 4’X5’ PATIOSTake the next 4’x5’ patio and position it next to the previous patio. Place the ledge section of the patio over t
POSITION THE 18”X 5’ LEFT AND RIGHT PATIOSAttach the left and right 18”x5’ patios to your deck using the Truss Head screws, Washers, and hex nuts as s
86HEX NUTS2” SCREWSLONG POSTATTACH THE LADDER POSTAttach the remaining Long Square Post to either the left or right side of your deck depending on whe
97bATTACH BOTTOM SUPPORT CHANNELS ANGLE SUPPORT BARUse the Deck reference drawings on the previous page and the detailed Close Up drawings below.Havin
Kommentare zu diesen Handbüchern